From: Larry Platzek (larryp@inow.com)
Date: Wed Nov 06 2002 - 22:55:06 CET
The thing you need to do is use the dos setup program to
set the card's io and irq as you want. Then with mulinux you do not need
to set io or irq on the invoking of the driver code, it will findout by
its self and tell you what it is using in you log file.
I am doing this from memory so could be wrong please let me know if I am
and I can get out the hardware and software to test but not untill
midnight will be leave computer very shortly.
Larry Platzek larryp@inow.com
On Wed, 6 Nov 2002, Maarten van Vuure wrote:
> Date: Wed, 6 Nov 2002 20:22:06 +0100
> From: Maarten van Vuure <m.van.vuure@freeler.nl>
> Reply-To: mulinux@sunsite.dk
> To: mulinux@sunsite.dk
> Subject: 3Com509
>
> Good day to you all,
>
> I am using a 3Com509 B TPO (in ISA mode) but I can't get it to work.
> Because of that I tried to use an utility of David Becker ( www.scyld.com something like that ) to install the card.
> The utility is able to spot the card and affirmative about the i/o number being ' 0x300 ' . When I tried to set-up the eth0 in mulinux I got: ' i/o symbol not found ' . Under Dos/Windows I used a set-up utility from 3Com and the card tested good on i/o 0x300 and IRQ 10. What am I doing wrong, can I manually make changes to a configuration file ?
> Can anyone give me proper instruction / share experience?
> Thanks in advance,
> Maarten
>
>
---------------------------------------------------------------------
To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.dk
For additional commands, e-mail: mulinux-help@sunsite.dk
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:23 CET