From: winsor (winsor@wi.net)
Date: Sun Apr 09 2000 - 19:13:00 CEST
in rc.local
insmod /location/of/module "module parameters"
then after that add the routing commands specified during setup of the
first eth interface using eth1 rather that eth0
good luck
winsor
Hans-Jürgen wrote:
>
> > > On Wed, Apr 05, 2000 at 08:34:13PM +0200, Hans-Jürgen nicely wrote:
> > > > Does anyone use Mulinux as Gateway and can tell me how two configure
> > > > multiple ethernet cards?
> > > > I have two ne2000 clones and later i will have one ne2000 and one 3Com
> > card.
> > > >
> > > > What i tried:
> > > > use setup -f eth and choosed ne as module and put io=240,300 irq=3,10
> as
> > > > parameters.
> > > > the two cards were detected but i could not configure the second card
> > with
> > > > ifconfig and route cause the device eth1 was not found.
> > > >
> > >
> > >
> > > Configure card-1 with standard "setup network", and card-2 with
> > > "setup local". A true support for multiple NIC card are under
> > > development ( a TODO)
> > >
> Ok i tried that but i get the message: modul not found if i try to load a
> modul with setup -m ne.o or
> setup -m /tmp/modules/preferred/net/ne.o. How do i load a module with in
> rc.local and how can i handle the parameters to the modul?
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk
> For additional commands, e-mail: mulinux-help@sunsite.auc.dk
-- The more I use Linux, the harder Windows becomes to use. Point and click software is too restrictive and difficult to do anything productive with. --------------------------------------------------------------------- To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk For additional commands, e-mail: mulinux-help@sunsite.auc.dk
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:13 CET