From: Sven Conrad (SvenConrad@gmx.de)
Date: Thu Apr 06 2000 - 10:58:47 CEST
> Does anyone use Mulinux as Gateway and can tell me how two configure
> multiple ethernet cards?
Please.... tell us about your networks. This can't be answersed in
general.
> I have two ne2000 clones and later i will have one ne2000 and one 3Com
card.
>
This only has effect to module loading. After successfull load you have
eth0, eth1.
> What i tried:
> use setup -f eth and choosed ne as module and put io=240,300 irq=3,10 as
> parameters.
> the two cards were detected but i could not configure the second card
with
> ifconfig and route cause the device eth1 was not found.
>
What does this mean? If both card are detected eth0 and eth1 should be
there. What are the message when loading module ne and what is "cat
/proc/net/dev" look like?
/sven
-- Sent through GMX FreeMail - https://www.gmx.net --------------------------------------------------------------------- To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk For additional commands, e-mail: mulinux-help@sunsite.auc.dk
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:13 CET